10.5m³/min Θερμαινόμενο Αποξηραντικό Προσρόφησης Τύπου Αέρα Στεγνωτήρας

Compared to a heatless air dryer, the air loss is much lower. The air loss of our heat desiccant type dryer is 6%. There is an independent electric heater. It improves the shortcomings of heatless regenerative dryers. That is large regeneration air consumption, short switching cycle, and high failure rate. The energy saving rate can reach more than 40%. So it makes the operation costs lower.

Επιπλέον, it also uses a thermostatic controller. Keep the regeneration air temperature constant. Επειτα, avoid the adsorbent from overheating.

Πρώτα, our adsorption air dryer adopts a long process design. Έτσι, it can guarantee an extremely low dew point. κατα δευτερον, there are diffusers at the bottom of the adsorption tower. It ensures enough contact time between compressed air and adsorbent. Without this device, there would be “dead spots” for adsorption.

Επιπλέον, it can reduce the impact of air current on the desiccant beads. Ετσι, it guarantees the service life. Τρίτον, our adsorbent filling is sufficient. So the dew point of our dryer is low and stable. Our dryer uses microcomputer intelligent automatic control. The air supply is continuous and stable. Intermittent air cuts will not occur. Easier to handle. Επομένως, the dew point fluctuation is very small.

Our desiccant type air dryer uses two kinds of adsorbents. Namely high-efficiency activated alumina and molecular sieves. The desiccant has a long service life.

Επιπλέον, our dryer adopts a wear-resistant pneumatic butterfly valve. Reliable performance and long life. The two-position, five-way solenoid valve is also a well-known brand. So it ensures reliable operation of absorption type dryer.

If needed, we can add a SUTO dew point meter. Με αυτόν τον τρόπο, it can achieve TSE dew point energy-saving control. εκτός, a variety of control methods are available. Αυτό είναι, interlocking control, remote communication, and IoT control. They can adapt to different requirements.

Επιπλέον, we can customize lower dew points. It can reach -70℃. Εξάλλου, we can also produce high-pressure adsorption air dryers. Max pressure is up to 100 μπαρ.

Lingyu is a famous desiccant type air dryer brand in China. Εξάλλου, our absorption type dryer usually works with famous compressor brands, such as Atlas Copco, Ingersoll Rand, Kobelco, Hitachi, και τα λοιπά.

PSA has wide application in the drying of gases. Adsorb at higher pressure. Desorb under reduced pressure. This is called pressure swing adsorption.

Generally carry out desorption at atmospheric pressure. It has little desorption effect if it adsorbs moisture under high pressure and reduces to atmospheric pressure. After depressurization, must purge regeneration air with low relative humidity. Με αυτόν τον τρόπο, the desorption can be completely desorbed. Επειτα, this is the PSA process of adsorption air dryer.

TSA refers to adsorption at lower temperatures. Επειτα, desorb at a higher temperature. This is another principle of desiccant type air dryers. Because the adsorption capacity will decrease with temperature increasing. During regeneration, the regeneration gas is purged to increase the temperature. So it will reduce the relative humidity.