11KW 15 Kompresor Udara Sekrup Putar HP dengan Pengering dan Tangki Pendingin

It adopts a large rotor low-speed design and advanced helical tooth technology. Lebih-lebih lagi, airend uses the Sweden SKF brand tapered roller bearings. The all-in-one air compressor has low noise and low energy consumption.

Permanent magnet motors use high-efficiency permanent magnets. The magnetic field is strong. It doesn’t fail at high temperatures. PM motors have no motor bearings, so can eliminate the failure point. The transmission efficiency reaches 100%. It realizes low noise, low energy consumption, and low maintenance costs.

Ini 15 hp rotary screw air compressor with dryer is with the inverter. The air pressure can remain stable. The pressure does not fluctuate, which helps to cut. The cutting speed is uniform. The cutting edge is smooth and flat without burrs. It has high processing precision. Di samping itu, it is good for the laser head. It can avoid pressure fluctuations affecting and damaging the laser head and lens.

The 11kw all-in-one air compressor is equipped with a refrigerated dryer. It can effectively remove moisture. The pressure dew point of exhaust air reaches 3~10℃. So it can ensure access to pure, dry compressed air. Di samping itu, this refrigerant dryer is a high inlet temperature type. So it has wide applicability. Even in hot areas, its cooling effect will not be bad.

Selain itu, there is also an important point for this refrigerated dryer. Our compressed air enters the dryer evaporator. They exchange heat with refrigerant. Then the temperature of compressed air decreases. Pada saat ini, the moisture in the saturated air will come out. After separation by the gas-water separator, the water will be discharged through the automatic drain. Saat ini, the low-temperature dry air will be not directly discharged. Alih-alih, it goes again to the hot and cold air exchanger. After heat exchange, the air temperature rises. Akhirnya, the warm compressed air leaves the dryer. This is important for our laser cutter. If the air is cold, it will also create moisture on our lenses.

It adopts high-precision filter paper and can completely filter out dust and impurities in lubricating oil. It can ensure the clean quality of compressed air and provide a clean air source for laser cutting. So effectively protect the cutting machine lens. Before we need to wipe the protective lenses every two hours. Now it can be extended to 200 hours to wipe once, thus it improves our production efficiency. Di samping itu, it can reduce pressure difference and energy consumption.

It adopts high-precision filter paper and can completely filter out dust and impurities in lubricating oil. It can ensure the clean quality of compressed air and provide a clean air source for laser cutting. So effectively protect the cutting machine lens. Before we need to wipe the protective lenses every two hours. Now it can be extended to 200 hours to wipe once, thus it improves our production efficiency. Di samping itu, it can reduce pressure difference and energy consumption.

Itu 15 hp rotary screw air compressor with dryer has a 400L air storage tank. It can cool air temperature and stabilize pressure. It also avoids frequent loading and unloading of the compressor, reduces mechanical wear.

The integrated all-in-one air compressor is small in size. It organically combines an air compressor, tangki, pengering berpendingin, and filter into a whole. If some occasions are limited by space, it is good to use this 4 di dalam 1 air compressor. Optimized pipeline design reduces pressure loss. Di samping itu, it uses fewer parts and connections, reducing the risk of machine failure and leakage.