11KW 15 냉동식 건조기 및 탱크가 포함된 HP 로터리 스크류 공기 압축기

It adopts a large rotor low-speed design and advanced helical tooth technology. 게다가, airend uses the Sweden SKF brand tapered roller bearings. The all-in-one air compressor has low noise and low energy consumption.

Permanent magnet motors use high-efficiency permanent magnets. The magnetic field is strong. It doesn’t fail at high temperatures. PM motors have no motor bearings, so can eliminate the failure point. The transmission efficiency reaches 100%. It realizes low noise, low energy consumption, and low maintenance costs.

이것 15 hp rotary screw air compressor with dryer is with the inverter. The air pressure can remain stable. The pressure does not fluctuate, which helps to cut. The cutting speed is uniform. The cutting edge is smooth and flat without burrs. It has high processing precision. 게다가, it is good for the laser head. It can avoid pressure fluctuations affecting and damaging the laser head and lens.

The 11kw all-in-one air compressor is equipped with a refrigerated dryer. It can effectively remove moisture. The pressure dew point of exhaust air reaches 3~10℃. So it can ensure access to pure, dry compressed air. 게다가, this refrigerant dryer is a high inlet temperature type. So it has wide applicability. Even in hot areas, its cooling effect will not be bad.

게다가, there is also an important point for this refrigerated dryer. Our compressed air enters the dryer evaporator. They exchange heat with refrigerant. Then the temperature of compressed air decreases. 이때, the moisture in the saturated air will come out. After separation by the gas-water separator, the water will be discharged through the automatic drain. 지금이 순간, the low-temperature dry air will be not directly discharged. 대신에, it goes again to the hot and cold air exchanger. After heat exchange, the air temperature rises. 마지막으로, the warm compressed air leaves the dryer. This is important for our laser cutter. If the air is cold, it will also create moisture on our lenses.

It adopts high-precision filter paper and can completely filter out dust and impurities in lubricating oil. It can ensure the clean quality of compressed air and provide a clean air source for laser cutting. So effectively protect the cutting machine lens. Before we need to wipe the protective lenses every two hours. Now it can be extended to 200 hours to wipe once, thus it improves our production efficiency. 게다가, it can reduce pressure difference and energy consumption.

It adopts high-precision filter paper and can completely filter out dust and impurities in lubricating oil. It can ensure the clean quality of compressed air and provide a clean air source for laser cutting. So effectively protect the cutting machine lens. Before we need to wipe the protective lenses every two hours. Now it can be extended to 200 hours to wipe once, thus it improves our production efficiency. 게다가, it can reduce pressure difference and energy consumption.

The 15 hp rotary screw air compressor with dryer has a 400L air storage tank. It can cool air temperature and stabilize pressure. It also avoids frequent loading and unloading of the compressor, reduces mechanical wear.

The integrated all-in-one air compressor is small in size. It organically combines an air compressor, tank, refrigerated dryer, and filter into a whole. If some occasions are limited by space, it is good to use this 4 ~에 1 공기 압축기. Optimized pipeline design reduces pressure loss. 게다가, it uses fewer parts and connections, reducing the risk of machine failure and leakage.